UV-5R Manufacture Software Programming Processġ) Download and open the manufacture software. Then you can check the settings you modified after reboot the radio.
Make sure it has enough power during the programming procedure.ġ) Open the CHIRP software (Latest Version), click "Download From Radio" under "Radio"Ģ) Select the corresponding cable driver port, and select Model "UV-5RX" under Vendor "Baofeng", then click "OK" to read the radio.ģ) And you will come to the page of Memories, in which you can adjust the limited parameters (Channel, TX Frequency, RX Frequency, CTCSS/DCS, High/Low Power, and Wide/Narrow Band, etc).Ĥ) Then if you switch to the page of Settings, you can adjust the limited parameters (VOX Function, Squelch, Backlit, DTMF, FM Radio, Voice Prompt, Scanning, VFO Mode, etc).ĥ) All the modification will be saved by clicking "Upload To Radio" under "Radio". Connect your Walkie Talkie with Computerġ) USB programming cable connects with the computer end.Ģ) Connect the other end of the cable with your walkie talkie.ģ) When both ends have been connected, turn on your radio. You can just plug in and use directly.ġ) Turn on the computer, check if your computer system meets the requirements.Ģ) Download the manufacture programming software on or CHIRP programming software.Ĥ. If you use an FTDI cable, it does not need to be installed with a driver. USB programming cable - The driver should be installed before programming.ġ) Find the corresponding driver of the system.Ģ) Click install and wait for the installation.ī. Windows XP, Windows 7, Windows 8 and Windows 10Ī. Operating System: Windows 98, Windows Me. Since the UV-5R series share the same manufacture programming software and CHIRP support most of Baofeng UV-5R models, this programming guidance is a helpful preference to the following model：īaofeng GT-3, BF-F8/BF-F8+, BF-F9, UV-5R+/UV-5R+Plus, UV-5RA/UV-5RA+/UV-5RAX+, UV-5RAX (2M/1.25M), UV-5RE/UV-5RE Plus, etc.
0 kommentar(er)
